ResMed AirFit F10

Description

Fitting Guide:

1. Remove the elbow from the mask by pressing the side buttons on the elbow and pulling it out.
2. Take off the lower headgear straps and hold the cushion to your face.  Align the bottom with the crease of your chin and the top with the corner of your eye.  Then pull the headgear over your head.
3. Undo the fastening tabs on the upper headgear straps.  Adjust both straps evenly until the mask feels stable, then reattach the tabs.
4. Bring the lower straps below your ears and loop the headgear into the lower hooks on each side of the frame.
5. Adjust the lower headgear straps evenly until the mask feels stable.  The fitting should be firm yet comfortable. Do not over tighten.
6. Connect device air tubing to the elbow, then attach the elbow to the mask by pressing the side buttons on the elbow in, then push it into the mask.  Turn on the device so it blows air.  You may need to make final adjustments if required after you lay down in bed.
7. To readjust the mask straps.  Undo the tabs of the upper headgear straps. Reposition both straps evenly, only enough so a seal is achieved, then reattach the tabs.  The mask is now ready to use.

Cleaning tips (outlined by the American Thoracic Society April 2020):

• Daily: clean full face mask cushion daily with a damp cloth and mild detergent, may use mask wipes
• Weekly: clean full mask system (including headgear) with warm water and mild soap (dish soap). Rinse with water and then air dry away from direct sunlight.

Recommended replacement every 6 months.